Standard Dimensions: 120x90x240(h) cm, 150x90x240(h) cm, 180x90x240(h) cm

Fume Hood Body:

Made of 1.2 mm galvanized steel and coated with epoxy polyester based electrostatic powder paint. In this way, it has become resistant to corrosion.

Fume Hood Front Sash:

Made of 6mm heat treated tempered glass. Motorized automatic glass door can be opened and closed upwards and downwards with buttons.

Fume Hood Control Panel:

MP series fume hoods have mediacell type inclined control panels. These sloping panels have a more ergonomic structure as they face towards the user, making it easier to reach the control equipment and sockets. One of the fume cupboard panels has gas and water valves, while the other panel has protection fuses, lighting switch, sockets, fan motor speed switch and motorized automatic glass control buttons. This model also has an air flow control monitor. The surface air flow rate can be monitored instantly via this monitor. When the suction speed of the fume hood falls below the standard, it gives an audible and visual alarm. If the suction speed drops below the standard speed as a result of problems such as front sash heigt position, motor failure, exhaust blockage, etc., poison gases may leak from the front opening to the lab environment. This situation must be intervened as it endangers the user.

Worktops of Fume Hood:

It can be changed upon request. Working surfaces that can be applied to our products;

Compact laminate resistant to chemicals)

This material is one of the most preferred products. It is a product with a high price-performance ratio. It is highly resistant to scratches and impacts. It is heat resistant up to 150 degrees. Its chemical resistance is good. However, if it is not cleaned carefully, it can leave stains over time. If necessary, compact laminate coating can be applied to the inner walls of the fume hood.

Stoneware

Industrial ceramic is a material produced as a single piece without any joints. The chemical resistance of ceramic stoneware fume hood worktops is very high. It is very resistant to all known chemicals except hydrogen fluoride and its solutions. It is very resistant to heat and scratches. Its impact resistance is limited. 12-18-25mm thicknesses are applied with or without a barrier. It can be produced with a cup sink (drip cup) from its own material for fume hoods. Ceramic coating can also be applied to the inner walls of the fume hood upon request.

Polypropylene

It is manufactured from polypropylene boards. It can be applied in 8 to 10 mm thickness and with skirting. Polypropylene fume hood countertop surface has very high acid and base resistance. Impact resistance is good. Scratch and heat resistance are low. If desired, PP coating can be applied to the inner walls of the fume hood.