Standart Dimensions: 120x75x220(h) cm, 150x75x220(h) cm, 180x75x220(h) cm

Fume Cupboard Body:It is made of 1.2mm galvanized steel and coated with epoxy polyester based electrostatic powder paint. In this way, it has become extremely resistant to corrosion caused by chemical vapors.

Fume Cupboard Front Sash:Made of heat treated glass. The glass sash can be opened and closed by moving up and down. It is equipped with a counter weight system to provide comfortable movement. Left at any height, it remains fixed at that level.

Fume Hood Control Panel:SP series fume cupboards have standard European norm flat control panels on both sides. These panels are at hand level of the user and are in a position protected from any liquid leakage may come from the worktop. Access to control buttons, valves and sockets is easier. One of these panels has gas and water valves, and the other has control buttons, sockets, etc. electrical equipment is installed. This model also includes an air flow control monitor. The air flow rate can be observed instantly via the digital air flow monitor. When the suction speed of the fume hood falls below a certain limit, it gives an audible and visual alarm. If the suction speed drops below the standard for various reasons, toxic gases may escape from the glass cover to the environment.

Exproof Features:

FC150-AISPEX is an Exproof fume cupboard model that does not cause explosion. Accordingly, all electrical components used have been selected as ex-proof. Sockets, switches, lighting fixtures, junction boxes, fan motor etc. All electrical devices meet ATEX standards.

Fume Hood Worktop: It can be changed optionally. Work surfaces that can be applied to our products;

Chemical Resistant Compact Laminate

This material is one of the most preferred surfaces. It is the product with the highest F/P ratio. Chemical resistance is good. It has high resistance to heat and impact. However, if cleaning is not taken care of, chemicals may leave stains on the surface over time.

Stoneware

It is a counter surface that is produced as a single piece without industrial ceramic joints. Its chemical resistance is very high. It has excellent resistance to all known chemicals except hydrogen fluoride and its solutions. It is very resistant to heat and scratching. Impact resistance is not good. The cost and deadline are high. 18-22-25mm thicknesses are applied with or without self-barrier. It can be produced together with a cupsink sink from its own material for fume hoods.